Surrey Wrought Iron Side Gate:
Select your "Made to Measure" sizes from above or choose from our "In Stock" sizes below:
Width of Gate: Taken as the actual gate (not opening size). This can be easily calculated - measure the distance between the pillars and reduce by 100mm (4").
Handcrafted in the UK by skilled craftsmen using the finest materials to provide ultimate durability and quality. Unlike some competitors, our gate material is thicker, comes complete with a 10 year workmanship guarantee, adjustable hinges/ pins. Therefore, if fitting to existing posts/ pillars - this gate is ready to hang with no extras required.
Height of Gate: Taken to the highest point of each gate. We recommend allowing a 50mm (2") clearance between the bottom edge of gate and driveway (as long as the drive is level). If you require a more exact height, please contact us to order.Gate Furniture (hinges etc): 2 x adjustable hinges, hinge pins, closing receiver and opening latch included with each gate (enough to hang direct on existing posts/ pillars). As standard, the position of the hinge will be 6" (150mm) from the bottom edge of gate and 6" (150mm) from top edge of gate. If you require these to be different (if for example you already have pins set into a post/ pillar), please call us.
Why choose us
Hand crafted gates individually made here in the UK
Can be made to ANY width and height
We construct gates to a very high standard, using the correct size metal for each gate depending on the style and size. This gives you a very strong gate which will last for many years
Adjustable hinges and opening latch are included with your gate
10 Year workmanship guarantee against welds
One of UK's largest gate manufacturers
Delivered straight to your door
Working out the required size is an important yet simple task to complete but we are always at hand to assist you through the process (0800 6124 965)
Calculating Side Gate width between existing Pillars or Posts:
Take three measurements, top, middle and bottom (as below).
Take the shortest of the three measurements and reduce by 100mm (or 4"). This allows for the hinge (inc pins) and opening gap. The final figure will be the actual width of gate required.
For example: Top: 1m 155mm | Middle: 1m 150mm | Bottom: 1m 145mm - shortest measurement would be 1m 145mm - reduce by 100mm = Actual Gate Width of: 1m 045mm
|Hanging Style||40mm x 40mm|
|Bottom Rail||40mm x 40mm|
|Top and Middle Rail||40mm x 10mm|
|Main Infill Bars||16mm|
|Handcrafted in the UK||Bespoke, any width or height|
|Guarantee||10 year against gate welds|